Tuesday, 27 April 2021

BSC2021: Hill Toppers

 One of the challenges for these boards is to keep a balance between making tall hills but also keeping the boards to a manageable size.  But limiting the hills to 3" height leaves the hills a bit less impressive.  So I've taken some left over insulation board and built some hill toppers.

Not much to them.  I cut two layers of insulation board and an MDF base.  Stuck them together with carpet tape, and then did some shaping with the hot wire cutter and utility knife. 





I left space for a little step, just wide enough for an infantry figure.





As a bonus, I will have a few more hills to use in other games!





No comments:

Post a comment